Fischer 507583 Bolt Anchor FBN II M10 x 100mm Hot-Dip Galvanised Pack x 20

• Drill hole diameter d0 10 [mm]
• Min. drill hole depth for through fixings h2 168 [mm]
• Anchor length l 176 [mm]
• Max. usable length hef,max./hef,min. tfix 100/110 [mm]
• Thread Ø x length M 10 x 136 [mm]
• Width across nut SW 17 [mm]
• The fischer bolt anchor FBN II is a steel anchor for cost-effective fixings in non-cracked concrete
• Due to the long thread and the two anchorage depths, the fischer bolt anchor FBN II can be used in a particularly flexible manner
• The bolt anchor is also suitable for stand-off installation as well as pre-positioned and in push-through installation
• The bolt anchor is made of hot-dipped steel and is suitable for railings, handrails or consoles

Top Features

• With assessment document (ETA) the hot dipped galvanized steel version is covered for external use with variable working life depending on environment and corrosion conditions
• The FBN II achieves maximum load-bearing capacity with standard anchorage depth
• This means: fewer fixing points and smaller anchor plates
• If the reduced anchorage depth is used, then this lowers the drill hole depth and simplifies installation
• Component tolerances are balanced out with the long thread
• In addition, FBN II is also suitable for stand-off installations. This increases flexibility. Simple assembly due to few taps and minimal slippage

Advantages

• The standard anchorage depth achieves the maximum load-bearing capacities
• This means that fewer fixing points and smaller anchor plates are required
• The reduced anchorage depth reduces the drill hole depth
• This minimises the amount of time needed for installation whilst increasing flexibility
• The first bolt anchor with variable working life covers the usage of bolt anchors in wet conditions and outdoor areas
• The long thread balances component tolerances and stand-off installations, and thus increases flexibility
• Fewer hammer blows and the minimal torque slippage allow for a noticeably simpler assembly
• The drive-in pin protects the threaded screw from damage, and as such ensures a faster installation and dismantling of the fixture

Functioning

• The FBN II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions
• Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut).
• When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall
• The head embossing offers a simple control of the anchoring.
• In the case of series installation, we recommend using the FABS bolt anchor setting tool

Load Table for Downloading

https://content.fischer.de/cbfiles/fischer/lastentabelle/lt_01_fbn-ii_f_%23sen_%23aip_%23v2.pdf

Technical Data Sheet for Downloading

https://content.fischer.de/cbfiles/fischer/zulassungen/tdb_01_fbnii_f_%23sen_%23aip_%23v1.pdf

https://content.fischer.de/cbfiles/fischer/zulassungen/tdb_01_fbnii-hdg_f_%23sen_%23aip_%23v1.pdf

Approvals ETA for Downloading

https://content.fischer.de/cbfiles/fischer/zulassungen/eta/zd_etab_f_07-0211_%23sen_%23aip_%23v1.pdf

https://content.fischer.de/cbfiles/fischer/zulassungen/eta/zd_etab_f_18-0101_%23sen_%23aip_%23v2.pdf

https://content.fischer.de/cbfiles/fischer/zulassungen/zd_dop_fbn-ii-1_f_%23sen_%23aip_%23v1.pdf