Fischer 506896 Highbond Anchor FHB II-A L M 12 x 100/100 gvz Pack x 10

• The fischer Highbond rod anchor FHB II-A L is produced from zinc-plated steel
• The torque-controlled composite anchor can be processed with the Highbond special mortar FIS HB or the mortar cartridges FHB II-P and FHB II-PF HIGH SPEED
• When tightening the hexagon nut, the anchor rod cones are pulled into the mortar shell, which expands against the drill hole wall
• Using the fischer Highbond system FHB II means that large machines and heavy steel constructions are securely installed within internal areas

Top Features

• Maximum load values due to large anchorage depth
• This means fewer fixing points and smaller anchor plates are required
• Optimised anchor rod for the highest tensile loads
• Optimised for low axial and edge distances in cracked concrete
• No drill hole cleaning is required when using a resin capsule
• This saves time
• ETA approval for cracked concrete

Advantages

• The large anchorage depth of the anchor rod FHB II-A L allows the system to achieve maximum load values
• Thus fewer fixing points and smaller anchor plates are required
• The cone shape of the FHB II-A L anchor rods has been specially optimised for high tensile loads
• As a result, the best performance in cracked concrete is achieved
• The FHB II-A L anchor rod is approved for use both with capsules and with injection mortar
• This guarantees maximum flexibility in the application
• No drill hole cleaning is required, if the FHB II-A L anchor rod is used in combination with the FHB II-P/-PF capsule
• This saves precious installation time
• When using the FHB II-A L in combination with the injection mortar FIS HB, push-through installation with annular gap filling is possible without the use of any further tools

Functionality

• The FHB II-A L is a bonded anchor with torque-controlled expansion for pre-positioned and push-through installation
• When using FHB II-A L in push-through installation, the annular gap is to be filled with the injection mortar FIS HB
• The anchor rod can be set either with injection mortar FIS HB or with the capsule FHB II-P / FHB II-PF HIGH SPEED, and is fully bonded in the drill hole
• When tightening the hexagon nut, the anchor rod cones are pulled into the mortar shell, which expands against the drill hole wall
• The styrene-free vinylester mortar fully seals the drill hole
• When using the resin capsule, set the anchor rod through rotating and hitting motions with a hammer drill
• Use the RA-SDS setting tool, Art.-No. 62420

Assemby Instructions

https://fiproductmedia.azureedge.net/media/Marketing%20Materials/Installation%20Instructions/MA_01_FHBII_F_SALL_AIP_V1.pdf

ETA Certification

https://fiproductmedia.azureedge.net/media/Certification%20Documents/ETA%20European%20Technical%20Assessment/fischer/ZD_ETAB_F_05-0164-1_SEN_AIP_V1.pdf